Akai APC 40 Midi Trigger Stuck On

How-To
1

Hello !

I am trying to map my Akai APC 40 right now. I have full control of my Midi Faders using the midi modifier, but when I try mapping a GLOW effect to a midi launch button it jumps the effect to 1.0 (Full) and it stays at the value unless brought down with a fader. My end goal is to be able to bump the glow effect on / off with each hit of the launch button.

Thanks in advance !!!

2

That sounds like the MIDI controller is just sending active and not following up with an inactive message. Usually you can control this with the drivers or tools that come with the MIDI controller, but you might be able to get away with using condition modifiers to take the input and only activate on change.

– Ryan