Sockpuppet connection on Disguise switches Notch layer to Inactive

Hello,

I have a notch block running on a layer on a Disguise VX2. It functions normally until I patch it to DMX (I have a DMX connection functioning from an MA3 console running in MA2 mode, the D3 DMX monitor is showing incoming DMX signal) and then the Notch block shows as [inactive]. Am I missing something?

Whoops - solved. Mods can trash this post if they like.

Problem was solved by upgrading to current release ( r21.0.4 ) and also ensuring that the required mapping is specified in the sockpuppet bank editor in addition to patching the layer to be controlled. Took me a bit to figure that one out.

1 Like